RFI Power Line Filters

F1100/F1150/F1199

• Most economical design
• Ideal for general purpose, common mode applications
• Available in standard (F1100) and low-leakage (F1150/ F1160/ F1170/ F1180/ F1190/ F1199) models

Catalog Page

F1200/F1250/F1299

• Designed for general purpose, common mode and differential mode applications
• Protection from pulsed, intermittent, or continuous RFI
• Higher line-to-line attenuation for protection from pulsed, intermittent, or continuous RFI
• IEC connector up to 10 amps
• Available in standard (F1200) and low-leakage (F1250/ F1260/ F1270/ F1280/F1299) models

Catalog Page

F1300/F1350/F1399

• Designed for motor, capacitive, and low-impedance loads
• T-circuit configuration
• Dual coils for higher performance in unknown RFI scenarios
• IEC connector and PC mounted versions available

Catalog Page

F1900

• Designed for equipment requiring UL 1410 approval (consumer electronics)
• UL 1414 approved components
• 10 times greater differential mode protection than F1100 Series

Catalog Page

F1400

• Compact case sizes in 6 and 10 amp models
• IEC connector in 3 and 6 amp models
• Low leakage current
• High peak current design – high insertion loss for switching power supply emissions

Catalog Page

F1500

• L-circuit configuration
• IEC connector plus common and differential mode performance
• High inductance design
• Three times more attenuation than F1200 Series
• Available with 0.250” quick connect terminals or wire lead

Catalog Page

F1600

• T-section, dual coil design
• High insertion loss for switching power supply emissions
• Low leakage design
• Integral IEC connector and compact case
• Current ratings up to 10 amps
• In fused IEC connector and PC mounted versions

Catalog Page

F1700/F1799

• For applications with higher differential mode noise
• Higher line-to-line capacitance
• Protection from pulsed, intermittent, or continuous RFI
• Integral IEC connector
• A cost-effective replacement for independent coil designs in SMPS applications

Catalog Page

F1760/F1770/F1780

• 3, 6, 10, and 20 amp RFI Filters for switching applications
• For use when switching power supplies, SCRs and TTL circuits
• Protection from pulsed, intermittent, or continuous RFI
• Effective CM and DM suppression down to 150 KHz
• Stud and quick connect versions availabl

Catalog Page

F2700

• Designed for FCC “B” and VDE “B” switching power supply applications
• High inductance design provides improved performance below 100 KHz
• Compact package
• Available in 3 and 6 amp ratings
• Integral fused IEC connector and on/off power switc

Catalog Page

F2800

• Designed for FCC “B” and VDE “A” switching power supply applications
• Available in ratings up to 15 amps
• Low leakage design
• Reduces common mode and differential mode noise from 100 KHz to 30 MHz

Catalog Page

F5100

Catalog Page

F5200

Catalog Page

F5500

Catalog Page

F5600

Catalog Page

F5700

Catalog Page

F5900

Catalog Page

Single Phase Filter Cutouts

Catalog Page