RFI Power Line Filters
Single Phase Filters: High Performance/Switching

• Compact case sizes in 6 and 10 amp models
• IEC connector in 3 and 6 amp models
• Low leakage current
• High peak current design – high insertion loss for switching power supply emissions

Catalog Page

• L-circuit configuration
• IEC connector plus common and differential mode performance
• High inductance design
• Three times more attenuation than F1200 Series
• Available with 0.250” quick connect terminals or wire lead

Catalog Page

• 3, 6, 10, and 20 amp RFI Filters for switching applications
• For use when switching power supplies, SCRs and TTL circuits
• Protection from pulsed, intermittent, or continuous RFI
• Effective CM and DM suppression down to 150 KHz
• Stud and quick connect versions available

Catalog Page

• Designed for FCC “B” and VDE “A” switching power supply applications
• Available in ratings up to 15 amps
• Low leakage design
• Reduces common mode and differential mode noise from 100 KHz to 30 MHz

Catalog Page

• T-section, dual coil design
• High insertion loss for switching power supply emissions
• Low leakage design
• Integral IEC connector and compact case
• Current ratings up to 10 amps
• In fused IEC connector and PC mounted versions

Catalog Page

• For applications with higher differential mode noise
• Higher line-to-line capacitance
• Protection from pulsed, intermittent, or continuous RFI
• Integral IEC connector
• A cost-effective replacement for independent coil designs in SMPS applications

Catalog Page

• Designed for FCC “B” and VDE “B” switching power supply applications
• High inductance design provides improved performance below 100 KHz
• Compact package
• Available in 3 and 6 amp ratings
• Integral fused IEC connector and on/off power switch

Catalog Page